8KVA 220v 50Hz Converter
ELECTRON FREQUENCY CONVERTER
60 to 50 Hz · 50 to 60 Hz · 60 to 60 Hz Isolation · 50/60 to 400 Hz
Solid State Frequency Converter Specifications 400Hz
| Model | 8KSS60400/50400 | ||||
| Capacity | 8KVA/6.4KW | ||||
| Input | |||||
| Voltage | 220V -15%/+20% *see note | ||||
| Current
Requirement |
220V – 41.8A @ Full Load (62.7A @ Current limit) | ||||
| 120V – 76.7A @ Full Load (115A @ Current limit) | |||||
| Frequency | 50Hz or 60Hz ±5% | ||||
| Phase | Single | ||||
| Output | |||||
| Voltage | 120V (Locked) | ||||
| Voltage Regulation | ±1% | ||||
| Frequency | 400Hz | ||||
| Output Waveform | Pure Sinewave | ||||
| Frequency Regulation | ±0.016Hz (Xtal oscillator) | ||||
| Harmonic Distortion | <3% (100% linear load.) | ||||
| Output Waveform | Pure Sinewave | ||||
| Output Current @ .8pf | 220V – 36.4A | ||||
| 115V – 66.7A | |||||
| Overload@150%
for 30 seconds |
220V – 54.6A | ||||
| 120V – 100.1A | |||||
| Efficiency | |||||
| AC to AC | >85% | ||||
| Power Factor | 0.8 | ||||
| Crest Ratio | 3:1 | ||||
| Protection | |||||
| Overload | 150% 30Sec cutoff (Current Limited) | ||||
| Overload Capacity | 100% continuous,110-150% load 30 seconds, over 150% causes unit to shut down. Auto restart upon removal of the overload. | ||||
| Short Circuit | Unit will cut off and must be manually restarted | ||||
| EMI Filter | 10-100KHz at 40dB, 100KHz-100MHz at 70dB | ||||
| Audible Alarm | |||||
| Overload | Sounds continuously | ||||
| Fault | Sounds continuously | ||||
| Indicator | |||||
| LCD | Converter status, O/P voltage, O/P frequency, O/P Power | ||||
| LED |
|
||||
| Environment | |||||
| OperationTemp. | 0-40° C; 32-104° F | ||||
| Relative Humidity | 20-90% non-condensing | ||||
| Audible Noise | Less than 72dB (at 1 meter) | ||||
| Physical | |||||
| Input | Terminal Block | ||||
| Output | Terminal Block (Worldwide outlets available) | ||||
| Net Weight | 366lbs/166.4kg | ||||
| Width | 18.9in/48cm | ||||
| Depth | 13.6in/34.5cm | ||||
| Height | 34in/86.4cm | ||||
| Note: Input voltages of 208V single phase (phase-to-phase on a 3-phase 120/208V line) – with 2 hot lines and 240V single phase (from a 120/20V split-phase source) – 2 hot lines are both acceptable with one hot on the input N ternimal, and another hot on the L2 input terminal. | |||||
