1KVA Solid State Frequency Converter Specifications 400Hz

Model 1KSS60400/50400
Capacity 1KVA/700W
Input
Voltage 120V or 220V *see note
Voltage Range 120V -15%/+20% or 220V -15%/+20%
Current
Requirement
220V - 5.2A @ Full Load (7.8A @ Current limit)
120V - 9.6A @ Full Load (14.3A @ Current limit)
Frequency 50Hz or 60Hz
Phase Single
Output
Voltage 115V (Locked)
Voltage Regulation ±1%
Frequency 400Hz
(50/60hz available)
Frequency Regulation ±0.016Hz (Xtal oscillator)
Harmonic Distortion <3% at 100% linear load
Output Waveform Pure Sinewave
Output Current @ .7pf 220V - 4.5A
120V - 8.3A
Non-Linear Peak
Current for 30 sec.
220V - 6.8A
120V - 12.5A
Power Factor 0.9
Efficiency
AC to AC >85%
Overload Capacity 110% continuous,110-150% load 30 seconds, over 150% causes unit to shut down. Auto restart upon removal of the overload.
Short Circuit Unit will cut off and must be manually restarted
EMI Filter 10-100KHz at 40dB, 100KHz-100MHz at 70dB
Over Temperature Inverter auto cut-off when heat sink temp over 80ºC
Audible Alarm
Overload Sounds continuously
Converter Fault Sounds continuously
Indicator
LCD Converter status, Input & Output voltage - frequency, loading %
LED
Line: Green LED Inverter: Green LED
Fault: Red LED Overload: Yellow LED
Environment
OperationTemp. 0-40° C; 32-104° F
Relative Humidity 20-90% non-condensing
Audible Noise Less than 45dB (at 1 meter)
Physical
Net Weight 67.5lbs/30.7kg
Width 7 1/8in/18.1cm
Depth 16in/40.6cm
Height 19 3/8in/49.3cm
Note: Input voltages of 208V single phase (phase-to-phase on a 3-phase 120/208V line)- with 2 hot lines and 240V single phase (from a 120/20V split-phase source) - 2 hot lines are both acceptable with one hot on the input N ternimal, and another hot on the L2 input terminal.

Specifications subject to change without notice.



Print This Page